Adding Front Brake Fluid - Husqvarna FC 450 2014 Repair Manual

16
BRAKE SYSTEM

Adding front brake fluid

Warning
Danger of accidents
If the brake fluid level drops below the specified marking or the specified value, this is an indication that the brake sys­
tem is leaking or that the brake linings are completely worn down. Check the brake system and do not continue riding.
A
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
-
Avoid contact with skin and eyes, and keep out of the reach of children.
-
Wear suitable protective clothing and goggles.
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
A
Warning
Danger of accidents
-
Change the brake fluid of the front and rear brake according to the service schedule.
Warning
Environmental hazard
-
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
------so1eoo-10
Brake system failure.
Reduced braking efficiency due to old brake fluid.
Hazardous substances cause environmental damage.
Preparatory work
Check the front brake linings. (..- p. 109)
Main work
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
Remove screws
Remove cover
Add brake fluid to level fj.
Guideline
Level fj (brake fluid level below con-
tainer rim)
I
Brake fluid DOT 4 (..- p. 216)
Position the cover with the membrane. Mount and tighten the screws.
• Info
I
Clean up overflowed or spilled brake fluid immediately with water.
O.
8
with membrane@).
5 mm (0.2 in)
112