Husqvarna FC 450 2014 Repair Manual page 35

6
FORK, TRIPLE CLAMP
-
Install dust boot
-
Mount fork protector ring G).
-
Mount the preload spacers and spring.
Guideline
Spring rate
Weight of rider: 65 ... 75 kg (143 ...
165 lb.)
Weight of rider: 75 ... 85 kg (165 ...
187 lb.)
Weight of rider: 85 ... 95 kg (187 ...
209 lb.)
201359-10
-
Push the cartridge into the fork leg.
-
Press the cartridge against the spring and mount special tool @.
I
Support tool (T14020) (- p. 230)
-
Grease the O-ring of the rebound adjuster.
I
Lubricant (T158) (- p. 217)
-
Mount the rebound adjuster.
✓ The rebound adjuster must reach the stop before the piston rod turns with it.
In case of tight piston rod threads, it must be held to keep it from turning.
X If the rebound adjuster is not turned all the way to the stop, the rebound
damping cannot be correctly adjusted.
-
Hold onto nut
I Guideline
Rebound adjuster on the piston rod
-
Press the cartridge against the spring and remove special tool @.
-
Tighten the rebound adjuster.
I Guideline
Rebound adjuster on the axle clamp
-
Clamp in the fork vertically.
Guideline
I
Use soft jaws.
-
Fill with fork oil.
Oil capacity fork
leg without car-
tridge
201369-10
O.
4.8 N/mm (27.4 lb/in)
5.0 N/mm (28.6 lb/in)
5.2 N/mm (29. 7 lb/in)
@)
and tighten the rebound adjuster.
I
M12x1
I
M20x1
390 ml Fork oil (SAE 4) (48601166S1)
(13.19 fl. oz.)
I
30 Nm (22.1 lbf ft)
I
30 Nm (22.1 lbf ft)
(- p. 216)
33
I
I