Table of Contents
Advertisement
SHOCK ABSORBER, SWINGARM
9
Changing the swingarm bearing
Info
These operations are the same on both swingarm bearings.
-
Position the engine sprocket cover and mount in the holder.
Mount and tighten screws
Guideline
Screw, clutch slave cylinder
Remaining screws, chassis
-
Position the brake caliper and pull it back.
-
Position the brake line in the guide.
Finishing work
-
Install the rear wheel. (or p. 95)
-
Remove the motorcycle from the lift stand. (or p. 10)
Preparatory work
-
Raise the motorcycle with a lift stand. (or p. 10)
-
Remove the rear wheel. (or p. 95)
-
Remove the swingarm. (or p. 68)
8
C,.
and
M6
M8
70
10 Nm (7.4 lbf ft)
25 Nm (18.4 lbf ft)
Advertisement
Chapters
Table of Contents
