Removing The Fork Protector; Installing The Fork Protector; Conducting Major Fork Service - Husqvarna FC 450 2014 Repair Manual

6
FORK, TRIPLE CLAMP
6.9
.
.
6.10 Installing the fork rotector

Conducting major fork service

Info
The steps are identical for both fork legs.
u
C)
rotector
Preparatory work
-
Raise the motorcycle with a lift stand. (.,. p. 10)
-
Remove the front wheel. (.,. p. 92)
-
Remove the fork legs. (.,. p. 14)
Main work
Remove screws
-
Remove the screws on the right fork leg. Lift off the fork protector.
B00306-10
Main work
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
I
Remaining screws, chassis
-
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
I
Remaining screws, chassis
B00306-10
Finishing work
-
Install the fork legs. (.,. p. 14)
-
Install the front wheel. (.,. p. 92)
Condition
The fork legs are disassembled.
-
Disassemble the fork legs. (.,. p. 16)
-
Disassemble the cartridge. (.,. p. 19)
-
Disassemble the piston rod.(.,. p. 21)
-
Disassemble the screw cap with the membrane holder. (.,. p. 22)
-
Disassemble the screw sleeve. (.,. p. 23)
-
Check the fork legs. (.,. p. 24)
-
Change the pilot bushing. (.,. p. 26)
-
Assemble the screw sleeve. (.,. p. 27)
-
Assemble the screw cap with the membrane holder. (.,. p. 27)
-
Assemble the piston rod. (.,. p. 28)
-
Assemble the cartridge. (.,. p. 30)
-
Assemble the fork legs.(.,. p. 31)
200974-01
O
on the left fork leg. Lift off the fork protector .
15
O.
10 Nm (7.4 lbf ft)
I10Nm(7.41bf ft)