Assembling The Screw Sleeve; Assembling The Screw Cap With The Membrane Holder - Husqvarna FC 450 2014 Repair Manual

6
FORK, TRIPLE CLAMP
1,---....-------200865-10
Assemblin the screw sleeve
Info
The steps are identical for both fork legs.
Assembling the screw ca� with the membrane holder
Info
The steps are identical for both fork legs.
-
Slide the new pilot bushing @ onto the special tool.
I
Mounting tool (T14022) (- p. 231)
-
Ensure that special tool
the thread.
Guideline
I
Overhang
I
Threaded bushing (T14023) (- p. 231)
-
Position the pilot bushing in the screw sleeve with the special tool and press it in
all the way.
I
Mounting tool (T14022) (- p. 231)
-
Lubricate the special tool.
Fork oil (SAE 4) (48601166S1) (- p. 216)
Calibrating unit (T14021) (- p. 230)
-
Press the special tool through the new pilot bushing a number of times.
I
Calibrating unit (T14021) (- p. 230)
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the screw sleeve. (- p. 27)
-
Mount and lubricate O-ring
I
Lubricant (T158) (- p. 217)
-
Mount ring
-
Mount lock ring
Info
The seal ring is mounted when the piston rod is assembled.
200866-11
Preparatory work
-
Check the fork legs. (- p. 24)
Main work
-
Lubricate and mount O-ring
I
Lubricant (T158) (- p. 217)
-
Clamp the open end wrench in a vise. Position compression holder.
-
Mount the compression shim stack @ with the smaller shims facing downward.
8
is mounted and that there is an overhang to protect
O.
@.
fD.
O.
11 mm (0.04 in)
27