Installing The Water Pump Cover; Installing The Suction Pump; Installing The Ignition Pulse Generator - Husqvarna FC 450 2014 Repair Manual

17 ENGINE
17.5.18

Installing the water pump cover

17.5.19

Installing the suction pump

Installing the ignition pulse generator

17.5.20
-
Put the water pump cover seal in place.
-
Mount the water pump cover.
O
Mount screw with the sealing washer but to not tighten yet.
I Guideline
Screw, water pump cover
8
-
Mount screw but do not tighten yet.
I Guideline
Screw, water pump cover
-
Mount screw ti) and tighten all screws in a crisscross pattern.
I
Guideline
Screw, water pump cover
Oil the internal rotor and external rotor before mounting.
O.
-
Insert 0-ring
8
Position pin into the oil pump shaft from above.
Position pin ti).
8
-
Mount internal rotor
✓ The rounded sides of the external rotor face the engine case.
-
Position oil pump cover (D. Mount and tighten screws@.
Guideline
Screw, suction pump
cover
-
Position the ignition pulse generator.
• Info
I
Use the middle drill hole pair.
-
Mount and tighten screws
Guideline
Screw, crankshaft posi­
tion sensor
-
Position the cable and insert the cable sleeve into the engine case.
I
M6x25
I
M6x25
I
M6x55
and external rotor@).
M5 6Nm
(4.4 lbf ft)
0-
M5 6Nm
(4.4 lbf ft)
177
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
Loctite 243
® ™
Loctite 243
® ™