Removing The Fork Legs; Installing The Fork Legs - Husqvarna FC 450 2014 Repair Manual

6
FORK, TRIPLE CLAMP
6. 7 Removin the fork le s

Installing the fork legs

Preparatory work
-
Raise the motorcycle with a lift stand. (.- p. 10)
-
Remove the front wheel. (.- p. 92)
Main work
-
Remove screws
-
Remove screws
-
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not pull the hand brake lever if the front wheel has been removed.
-
Loosen screws (5) . Take out the left fork leg.
-
Unscrew screws
Main work
-
Position the fork legs.
✓ Bleeder screws
• Info
I
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
-
Tighten screws
I Guideline
Screw, top triple clamp
-
Tighten screws (5) .
I Guideline
Screw, bottom triple clamp
-
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
-
Position the brake line and clamp. Mount and tighten screws
B00300-11
Finishing work
-
Install the front wheel. (.- p. 92)
O
and take off the clamp.
8
and take off the brake caliper.
C,.
Take out the right fork leg.
O
face forward.
8.
M8
17 Nm (12.5 lbf ft)
12 Nm (8.9 lbf ft)
@).
25 Nm
Loctite 243
®
(18.4 lbf ft)
C,.
14
™