Table of Contents
Advertisement
6.25
Ad"usting steering head bearing
-
Remove lower steering head bearing
-
Remove the seal ring.
-
Grease and mount the new seal ring.
-
Press on the new bearing with a suitable tube as far as it will
go.
D00075-10
Finishing work
-
Install the lower triple clamp.
-
Install front fender.
-
Install the start number plate.
-
Install the front wheel.
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check steering head bearing play.
-
Remove the motorcycle from the lift stand.
-
Mount the handlebar cushion.
la
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
Main work
-
Loosen screws
-
Remove screw
-
Loosen and retighten screw@).
Guideline
Screw, top steering
head
-
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
-
Mount and tighten screw
Guideline
Screw, top
steering stem
-
Tighten screws
Guideline
Screw, top triple
clamp
-
Check steering head bearing play.
Finishing work
-
Mount the handlebar cushion.
-
Remove the motorcycle from the lift stand.
FORK, TRIPLE CLAMP 6
0.
(a
p. 41)
(a
p. 115)
(a
p. 116)
(a
p. 121)
(a
p. 43)
(a
p. 12)
(a
O.
8.
M20x1 .5
12 Nm (8.9 lbf ft)
8.
MS
20 Nm (14.8 lbf ft)
O.
MS
17 Nm (12.5 lbf ft)
(a
p. 43)
(a
p. 12)
...
®
Loctite
243
™
p. 12)
45
Advertisement
Chapters
Table of Contents
