Husqvarna FC 450 2018 Repair Manual page 39

0
I
C,.
-
Push on support ring
-
Sand the edges of the sliding bushings with 600 grit
sandpaper; then clean and grease the bushings.
I Fork oil (SAE 4) (48601166S1)
-
Push on lower sliding bushing
-
Mount upper sliding bushing (D .
Info
Without using a tool, pull the stack slightly apart
by hand.
-
Warm up the outside fork tube in area
sliding bushings.
Guideline
so c
I (122 °F)
0
-
Hold the lower sliding bushing with the longer side of the
special tool.
I Mounting tool (T14040S)
-
Slide on the outside fork tube.
-
Press the slide bearing all the way into the outside fork
tube.
-
Position the support ring.
-
Hold the seal ring with the shorter side of the special tool.
I Mounting tool (T14040S)
-
Press the seal ring and support ring all the way into the
outside fork tube.
-
Mount lock ring @ .
✓ The lock ring engages audibly.
O.
-
Mount dust boot
-
Mount fork protector ring G).
FORK, TRIPLE CLAMP 6
(8 p. 303)
0.
G
of the lower
(8 p. 323)
(8 p. 323)
37