Husqvarna FE 350 2014 Repair Manual page 30

6
FORK, TRIPLE CLAMP
-
Lubricate and mount dust boot
I
Lubricant (T511) (
Info
Always change the dust boot, seal ring, lock ring and support ring.
Mount the sealing lip with the spring expander facing downward.
-
Slide on lock ring(!}.
-
Lubricate and slide on seal ring (5).
I
Lubricant (T511) (
Info
Mount with the sealing lip facing down and the open side facing up.
-
Slide on support ring
-
Remove the special tool.
-
Grind the edges of the sliding bushings with sandpaper grit 600, clean the bush-
ings and lubricate them.
I
Fork oil (SAE 4) (48601166S1) (
201715-10
-
Slide on the lower sliding bushing
-
Mount the upper sliding bushing (D.
Info
Do not use a tool; pull the ends apart slightly by hand.
-
Warm the outer tube in area
I Guideline
50 °c (122 °F)
-
Slide the outer tube onto the inner tube.
-
Hold the lower sliding bushing with the longer section of the special tool.
I
Mounting tool (T14040S) (
-
Push the sliding bushing all the way into the outer tube.
-
Position the support ring.
-
Hold the seal ring with the shorter section of the special tool.
I
Mounting tool (T14040S) (
-
Push the seal ring and support ring all the way into the outer tube.
O.
r p. 257)
r p. 257)
8.
p. 256)
r
0-
f)
of the lower sliding bushing.
r p. 268)
r p. 268)
28