Husqvarna FE 350 2014 Repair Manual page 32

6
FORK, TRIPLE CLAMP
-
Pull out the piston rod and push it back in numerous times while pressing it to
one side slightly.
✓ Air bubbles emerge and the cartridge is bled.
-
Keep bleeding until no more air bubbles emerge.
✓ The piston rod moves out automatically to the middle of the total stroke
distance.
• Info
I
When fully bled, the correct air chamber length is achieved automatically.
-
Position spring.
-
Pull the spring down. Mount screw cap@).
• Info
I
When assembling, ensure that the screw caps are correctly mounted
according to the hydrostop needles.
Rebound damping side - red hydrostop needle, screw cap with
mark
Compression damping side - silver hydrostop needle, screw cap with
mark
-
Pull the spring down. Mount the open end wrench on the hexagonal part.
-
Hold the open end wrench. Tighten screw cap@).
Guideline
I
Screw cap on piston rod
I
Special socket (T14047) (
-
Push the outer tube up.
-
Clamp the outer tube in the area of the lower triple clamp.
I
Clamping stand (T1403S) (
-
Tighten screw cap
Guideline
I
Cartridge on outer tube
I
Special socket (T14047) (
201701-11
-
Mount the adjuster. Mount and tighten screw
I
Guideline
Screw, adjuster
201700-11
Alternative 1
-
Turn the adjuster of compression damping Gi) (mark
of rebound damping
REB.
COMP.
I
p. 269)
.,.
p. 268)
.,.
fD.
I
p. 269)
.,.
I
G, (mark all the way clockwise.
REB)
M8x0.75 118 Nm (13.3 lbf ft)
I
M51x1.5 40 Nm (29.5 lbf ft)
@).
M4x0.5 2.5 Nm
1
(1.84 lbf ft)
and the adjuster
COMP)
30
I
I