Installing The Lower Triple Clamp; Remove Screws - Husqvarna FE 350 2014 Repair Manual

6
FORK, TRIPLE CLAMP
6.26
lnstallin the lower tri
-
Remove screw
handlebar and set it aside.
• Info
I
Cover the components to protect them against damage.
Do not kink the cables and lines.
-
Remove O-ring
-
Take off the lower triple clamp with the steering stem.
-
Remove the upper steering head bearing.
Main work
-
Clean the bearing and sealing elements, check for damage, and grease.
I
High viscosity grease ('r p. 257)
-
Position the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
-
Check whether the top steering head seal
-
Mount protective ring
B01632-10
-
Position the upper triple clamp with the steering.
-
Mount screw
-
Position the clutch line next to the voltage regulator.
-
Position the fork legs.
✓ Bleeder screws
• Info
I
The compression damping is located in the left fork leg
adjusting screw). The rebound damping is located in the right fork leg REB
(red adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
8.
Remove screw (D , take off the upper triple clamp with the
8-
Remove protective ring
8
and O-ring (D .
8
but do not tighten yet.
0
face forward.
G,.
O
is correctly positioned.
COMP (white
32