Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FE 350 2014 Repair Manual

21 LUBRICATION SYSTEM

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding
-
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard
-
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Engine oil and gear oil get very hot when the motorcycle is ridden.
Hazardous substances cause environmental damage.
Preparatory work
-
Park the motorcycle on a level surface.
-
Remove the engine guard.(,.... p. 41)
Main work
-
Place a suitable container under the engine.
-
Remove oil drain plug
Info
Do not remove screws
-
Remove screw plug
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing surfaces.
-
Position oil screen (D with the O-rings on a pin wrench.
-
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
-
Push the oil screen all the way into the engine case.
-
Mount and tighten screw plug
Guideline
I
Screw plug, oil screen
-
Mount and tighten the oil drain plug
Guideline
I
Oil drain plug with magnet
O
with the magnet and seal ring.
f)
on both sides.
8
with oil screen (D and the O-rings.
8
with the O-ring.
I
M20x1 .5
O
with the magnet and a new seal ring.
I
M12x1.5
192
I
115 Nm (11.1 lbf ft)
I I
20 Nm (14.8 lbf ft)