ENGINE
18
-
Change the oil pump shaft.
-
Check the oil pump cover for damage and wear.
If there is damage or wear:
-
Change the oil pump cover.
18.4.6
Removing the crankshaft bearing inner race
18.4.7
Installing the crankshaft bearing inner race
18.4.8
Changing the connecting rod, conrod bearing and crank pin
-
Fix the crankshaft in the vise.
•
Info
I
Use soft jaws.
0-
-
Warm up special tool
Guideline
1150 °C (302 °F)
I
Tool for inner bearing race (58429037037) (
-
Push the warmed up special tool
press firmly together and pull jointly from the crankshaft.
-
Take off the compensating disk.
-
Repeat the operation on the opposite side.
-
Fix the crankshaft in the vise.
•
Info
I
Use soft jaws.
-
Slide on the compensating disk.
-
Heat the crankshaft bearing inner race in special tool
Guideline
1120 °C (248 °F)
I
Tool for inner bearing race (58429037037) (
-
Repeat the operation on the opposite side.
-
Ensure that the new crankshaft bearing inner race is flush.
•
Info
I
After replacing the crankshaft bearings, the crankshaft end play must be
measured.
Main work
O
-
Position crankshaft
in the press using special tool
I
Extrude plate, base (77229009000) (
-
Press the crank pin with the special tool out of the upper crank web.
I
Pressing tool for crankshaft, complete (75029047000) (
•
Info
I
Hold the lower crank web.
-
Remove the connecting rod and bearing.
p. 260)
r
O
onto the crankshaft bearing inner race,
O
and mount together.
p. 260)
r
8.
p. 263)
r
p. 262)
r
147