Installing The Fuel Tank - Husqvarna FE 350 2014 Repair Manual

Table of Contents

Advertisement

12
FUEL TANK, SEAT, TRIM
m
12.8

Installing the fuel tank

Danger
Fire hazard
Fuel is highly flammable.
-
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
-
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
A
Warning
Danger of poisoning
-
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Fuel is poisonous and a health hazard.
Main work
-
Check the routing of the throttle cable. (,r p. 39)
-
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
-
Make sure that no cables are trapped or damaged.
-
Mount the fuel tank breather.
-
Mount and tighten screw
I
Guideline
Remaining screws, chassis
-
Position the collar bushings and horn, fit and tighten screws@.
I
Guideline
Remaining screws, chassis
-
Attach the connector of the horn.
-
Attach connector
-
Remove the wash cap set.
-
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
I
Never let dirt enter the fuel line. Dirt in the fuel line clogs the injection
valve.
-
Lubricate the O-ring and connect plug-in connection
Info
I
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
-
Mount the seat. (or p. 76)
O
with the rubber bushing.
fs)
of the fuel pump.
78
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
8
of the fuel line.

Advertisement

Table of Contents
loading

Table of Contents