Adding Engine Oil; Checking The Engine Oil Pressure - Husqvarna FE 350 2014 Repair Manual

21 LUBRICATION SYSTEM

Adding engine oil

Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
21.5
Main work
-
Remove the oil filler plug
Fill engine oil to the middle
I
Engine oil (SAE 1 0W/50) (
Info
•
I
For optimal performance of the engine oil, do not mix different types of
engine oil.
If appropriate, change the engine oil.
-
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning
result in unconsciousness and/or death.
When running the engine, always make sure there is sufficient ventila­
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
-
Start the engine and check that it is oil-tight.
Finishing work
-
Check the engine oil level. (
-
Check the engine oil level. (
-
Remove the release screw of the chain adjuster.
-
Mount and tighten special tool
I Guideline
Oil pressure adapter
I
Oil pressure adapter (77329006000) (
-
Connect pressure tester
I
Pressure tester (61029094000) (
Danger
Danger of poisoning
result in unconsciousness and/or death.
-
When running the engine, always make sure there is sufficient ventila­
tion, and do not start or run the engine in an enclosed space without
an effective exhaust extraction system.
-
Start the engine and let it warm up.
-
Check the engine oil pressure.
Engine oil pressure
Engine oil temperature: 80 °C
(176 °F)
Engine speed: 1,600 rpm
Engine oil temperature: 80 °c
(176 °F)
Engine speed: 6,000 rpm
If the measured value is less than the specification:
O
with the O-ring from the clutch cover.
f)
of the level viewer.
,... p. 256)
Exhaust gases are toxic and inhaling them may
,... p. 191)
,... p. 191)
O.
I
M10x1
p. 266)
,...
8
to the special tool without the T-plate.
p. 262)
,...
Exhaust gases are toxic and inhaling them may
0.9 bar (13 psi)
2.5 bar (36 psi)
194
10 Nm (7.4 lbf ft)