Safety Advice; Repair Manual; Degrees Of Risk And Symbols; Work Rules - Husqvarna FE 350 2014 Repair Manual

2

SAFETY ADVICE

2.1 Re air Manual
Read this Repair Manual carefully and thoroughly before beginning work. It contains useful information and tips that will help you
repair and maintain your vehicle.
This manual assumes that the necessary special Husqvarna tools and Husqvarna workplace and workshop equipment are avail­
able.
2.2 Safe advice
A number of safety instructions need to be followed to operate the vehicle safely. Therefore, read this manual carefully. The safety
instructions are highlighted in the text and are referred to at the relevant passages.
Info
The vehicle has various information and warning labels at prominent locations. Do not remove information/warning labels. If
they are missing, you or others may not recognize dangers and may therefore be injured.
m 2.3
Degrees of risk and s mbols
Danger
Indicates a danger that will immediately and invariably lead to fatal or serious permanent injury if the appropriate measures
are not taken.
A
Warning
Indicates a danger that is likely to lead to fatal or serious injury if the appropriate measures are not taken.
A
Caution
Indicates a danger that may lead to minor injuries if the appropriate measures are not taken.
Note
Indicates a danger that will lead to considerable machine and material damage if the appropriate measures are not taken.
Warning
Indicates a danger that will lead to environmental damage if the appropriate measures are not taken.
2.4

Work rules

Special tools are necessary for certain tasks. The tools are not contained in the vehicle but can be ordered under the number in
parentheses. E.g.: bearing puller (15112017000)
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, O-rings, pins, lock washers) must be
replaced by new parts.
In some instances, a thread locker (e.g.
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged or worn parts.
After you complete the repair or service work, check the operating safety of the vehicle.
Loctite®)
is required. The manufacturer instructions for use must be followed.
7