Husqvarna FE 350 2014 Repair Manual page 72

EXHAUST
10
-
Mount and tighten screw
Guideline
I
Remaining screws, chassis
(FE 350 EU)
-
Connect plug-in connector
tension, and secure with a new cable tie.
-
Install the fuel tank. (,... p. 78)
-
Lift the rear frame slightly and position the shock absorber.
-
Mount and tighten screw
Guideline
Screw, top shock
absorber
-
Position the rear frame.
-
Mount and tighten screws
Guideline
Screw, subframe
CD
-
Remove screws on both sides.
-
Mount and tighten screws
Guideline
Screw, subframe
-
Lower the swingarm.
-
Position the angle lever and linkage lever.
-
Mount and tighten fitting @.
Guideline
I
Nut, linkage lever on angle lever
-
Mount and tighten screw@).
Guideline
Screw, bottom shock
absorber
Finishing work
-
Install the main silencer. (,... p. 71)
8.
fs)
of the lambda sensor, route the cable without
C,.
M10 60 Nm
(44.3 lbf ft)
0
on both sides.
M8 35 Nm
(25.8 lbf ft)
CD
on both sides.
M8 35 Nm
(25.8 lbf ft)
I
M14x1.5
M10 60 Nm
(44.3 lbf ft)
70
I I
25 Nm (18.4 lbf ft)
Loctite 2701
® TM
Loctite 2701
® TM
Loctite 2701
® TM
I 80 Nm (59 lbf ft)
Loctite 2701
® TM