Table of Contents
Advertisement
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-12.
Step 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
4.10 IPMI Setup Procedure
The KINO-DQM871-i1 features Intelligent Platform Management Interface (IPMI) that
helps lower the overall costs of server management by enabling users to maximize IT
resources, save time and manage multiple systems. The KINO-DQM871-i1 supports IPMI
2.0 through the optional iRIS-1010 module. Follow the steps below to setup IPMI.
The hardware configuration of the managed system (KINO-DQM871-i1) is described
below.
Step 1:
Install an iRIS-1010 module to the IPMI module socket (refer to Section 4.5).
Step 2:
Make sure at least one DDR3 SO-DIMM is installed on the KINO-DQM871-i1.
Step 3:
Connect an Ethernet cable to the RJ-45 connector labeled LAN2 (Figure 3-33).
®
4.11 Intel
AMT Setup Procedure
The KINO-DQM871-i1 is featured with the Intel® Active Management Technology (AMT).
To enable the Intel® AMT function, follow the steps below.
Step 1:
Make sure at least one DDR3 SO-DIMM is installed on the KINO-DQM871-i1.
Step 2:
Connect an Ethernet cable to the RJ-45 connector labeled LAN1.
Step 3:
The AMI BIOS options regarding the Intel® ME or Intel® AMT must be enabled,
Step 4:
Properly install the Intel® Management Engine Components drivers from the
iAMT Driver & Utility directory obtained from IEI Resource Download Center.
See Chapter 6.
Step 5:
Configure the Intel® Management Engine BIOS extension (MEBx). To get into
the Intel® MEBx settings, press <Ctrl+P> after a single beep during boot-up
Page 74
KINO-DQM871-i1 Mini-ITX SBC
Step 0:
Advertisement
Table of Contents
