XSCF Shell Procedures for Using COD
This section describes these tasks:
To Install a COD License
■
To Delete a COD License
■
To Trade a COD License
■
To Reserve Licenses for Allocation
■
To Increase or Decrease Headroom
■
To Disable Headroom
■
To Display COD Information
■
To Display COD License Status
■
To Display Usage Statistics for COD Resources
■
To Install a COD License
▼
This procedure installs a COD license and, if headroom is enabled, decreases
headroom to compensate for each new license. This automatic reduction in
headroom is designed to avoid accidental abuse of headroom. You can increase
headroom again manually after installing the COD license. See
Decrease Headroom" on page
1. Log in to the XSCF console with platadm privileges.
2. Type the addcodlicense command:
XSCF> addcodlicense license-signature
where license-signature is the complete COD license key assigned by the Sun License
Center. For example:
XSCF> addcodlicense \
01:84000000:104:0301010100:3:00000000:xxxxxxxxxxxxxxx
3. Verify that the license key was added to the license database by typing the
showcodlicense -r command.
The COD RTU license key that you added should be listed in the
showcodlicense output. See
10.
"To Display COD License Status" on page
Capacity on Demand (COD) Administration
"To Increase or
13.
7