Table of Contents
Advertisement
Important information
3.2.9
Installing the server enclosure in the rack
CAUTION
▶
For safety reasons, at least 2 people are required to install the
server enclosure in the rack because of its weight and size.
(For Japan, see "安全上のご注意".)
▶
Never lift the server enclosure into the rack using the QRLs on the
front panel.
▶
When connecting and disconnecting cables, observe the relevant
instructions in "Important Information" of the technical manual for
the corresponding rack. The technical manual is supplied with the
corresponding rack.
▶
When installing the rack, ensure that the anti-tilt mechanism is
correctly fitted.
▶
Do not extend more than one server enclosure out of the rack
simultaneously even if the tilt protection is in place. If several server
enclosures are simultaneously extended from the rack, there is a
risk that the rack could tip over. See the safety information of the
rack and the warning label.
▶
If the server enclosure/rack is intended for permanent connection to
the mains only an authorized specialist (electrician) is allowed to
work. Please follow the regulation of each country.
▶
If the server enclosure is integrated into an installation that draws
power from an industrial power supply network with an IEC309 type
connector, the power supply's fuse protection must comply with the
requirements for non-industrial power supply networks for the type
A connector.
3.2.10
Other important information
▶ During cleaning, observe the instructions in the corresponding operating
manual chapter "Operation" > "Cleaning the server enclosure".
▶ Keep all manuals close to the server enclosure. All documentation must be
included if the equipment is passed on to a third party.
34
Upgrade and Maintenance Manual
CX400 M6
Advertisement
Table of Contents
