Dimensions; Mounted With Standard Fixed Brackets (F39-Lgf); F3Sg-Ra Series; Mounting - Omron F3SG-2RE0430P30 User Manual

Wiring/Installation

4-3. Dimensions

4-3-1. Mounted with Standard Fixed Brackets (F39-LGF)

4-3-1-1. F3SG-RA Series

 Backside Mounting
F3SG-RA-30 Series
Dimension A
Dimension C1
Dimension D
Dimension P
Protective height
(C1)
0190 to 1230
1310 to 2270
2350 to 2510
*1. The number of brackets required to mount either one of emitter and receiver.
*2. Mounting an emitter or receiver with one bracket is possible for the models of protective height of 0160 to 0270. In this case, locate this bracket
at half the Dimension A (or at the center of the sensor length).
4-4-3-1. Mounting with Standard Fixed Brackets (F39-LGF)
- Use the brackets of specified quantities and locations according to the dimensions. The other brackets than described
above may not meet the specified ratings and performance.
- When you use the sensor in a situation where the sensor is under a load, increase the number of the brackets used.
- The Standard Fixed Bracket does not allow beam alignment.
F3SG-R
134
User's Manual
40
35
Standard Fixed
Bracket
(F39-LGF)
Standard Fixed
Bracket
(F39-LGF)
C1+18
4-digit number of the type name
(Protective height)
C1-50
20
Number of Standard
Dimension F
Fixed Brackets *1
2 *2 1000 mm max.
3 1000 mm max.
4 1000 mm max.
35
2-M5 or M6
9.2 2-M5 or M6
24.85
< Screw: M5 or M6 >
F3SG-RA-14 Series
Dimension A
4-digit number of the type name
Dimension C2
Dimension D
Dimension P
Protective height Number of Standard
(C2)
0160 to 1200
1280 to 2080
24.85
[ Unit : mm ]
C2+48
(Protective height)
C2-20
10
Dimension F
Fixed Brackets *1
2 *2 1000 mm max.
3 1000 mm max.