Omron TJ2-MC02 Hardware Reference Manual page 135

Hardware reference
Option Board Mounting
WARNING
Always Switch OFF the mains power supply to the Inverter before
removing any covers. Wait for the time specified on the Inverter
front cover for the capacitors to discharge. Not doing so may result
in electrical shock.
Preparation
When the Option Board is mounted on the RX Inverter, the Digital Operator
Display can not be directly connected back on the RX Inverter.
Step 1a
Mount the Option Board according the steps below.
Step 1b
Connect the Digital Operator Display using the 3G3AX CAJOP300-EE cable
or straight Ethernet cable.
Step 1c
Set the desired parameters of the RX Inverter with the Digital Operator
Display.
Step 2
Remove from the RX Inverter:
1. Digital Operator Display
2. Terminal cover
3. Front Cover
4. Operator connector.
HARDWARE REFERENCE MANUAL
fig. 57
129