Omron TJ2-MC02 Hardware Reference Manual page 116

Hardware reference
3.5.10 Yaskawa MECHATROLINK-II Servo Drives
You can also connect the following Yaskawa Servo Drives:
• Sigma-II series Servo Drive with a JUSP-NS115 MECHATROLINK-II
interface unit
• Sigma-V series Servo Drive
• Junma series Servo Drive
For details please refer to the manuals of these Drives.
3.5.11 MECHATROLINK-II Inverter MX2
The 3G3AX-MX2-MRT-E allows controlling, monitoring and
parameterization of an MX2 Inverter via a MECHATROLINK-II network. The
3G3AX-MX2-MRT-E serves as a gateway that passes communicated
register values from the MECHATROLINK-II network to the MX2 Inverter
and vice versa.
The illustration shows the external appearance of the 3G3AX-MX2-MRT-E
Unit.
A. Option board connector
B. LED indicators (RUN, ERR, RX, TX)
C. Warning label
D. Fieldbus connector
E. Grounding cable
F. Housing
G. Mounting screw
Four LED indicators allow easy diagnosis. An attached grounding cable is
sized to reach the ground terminals on all MX2 Inverter models. A feature in
the housing will retain the mounting screw when the Option Board is not
mounted to the Inverter. Please pay special attention to the Option Board
connector: It must be properly connected with the Inverter when the Option
Board is mounted.
HARDWARE REFERENCE MANUAL
fig. 44
underside
RUN ERR RX TX
3G3AX-MX2-MRT
A
B
C
D
E
F
G
110