Mitsubishi Electric FX3S Series User Manual page 182

FX /FX /FX
3S 3G 3GC
Built-in Positioning Functions
*2.
*3.
*4.
B - 138
Downloaded from ManualsNet.com
/FX /FX PLC User's Manual - Positioning Control Edition
3U 3UC
Setting value
Specifies a user
Pulse output destination device
*2
8
*4 Do not specify these values.
9 ~ E
Set "F" for a pulse output destination device if the device is not used for the Interrupt
F
Positioning (DVIT) instruction.
A device can only be specified if an FX
When using an FX PLC below Ver. 2.20, if "8" is set and then the specified Interrupt Positioning (DVIT)
3UC
instruction turns ON, an operation error (error code: K6763) will occur, and the instruction will not cause any
operation.
Y003 is available only when two high-speed output special adapters are connected to the FX
After setting a number in the range of 9 to E for the interrupt input signal, if the corresponding Interrupt
Positioning (DVIT) instruction turns ON, an operation error (error code: K6763) will occur, and the instruction
will not cause any operation.
search engine
9 One-speed Interrupt constant quantity feed - DVIT Instruction
Description of setting
*2
interrupt input command
for the interrupt input signal.
User interrupt input command
Y000
Y001
Y002
*3
Y003
/FX PLC Ver. 2.20 or later is used.
3U 3UC
9.3 Function and Operation
M8460
M8461
M8462
M8463
PLC.
3U