Table of Contents
Advertisement
3. Press {ON} to power on
"9. POWER ON/OFF"
• The circular level is displayed on
the screen.
• "" indicates bubble in circular
level. The range of the inside
circle is ±4' and the range of the
outside circle is ±6'.
Tilt angle values X and Y are also
displayed on the screen.
• "" is not displayed when the tilt
of the instrument exceeds the
detection range of the tilt sensor.
Level the instrument while
checking the air bubbles in the
circular level until "" is
displayed on the screen.
• When executing the measurement
program, if measurement starts with
the instrument tilted, the circular level
is displayed on the screen.
4. Center "" in the circular level
steps 1 to 2
• If the bubble is centered, move to
step 9.
5. Turn the instrument until the
telescope is parallel to a line
between levelling foot screws A
and B, then tighten the horizontal
clamp.
7. SETTING UP THE INSTRUMENT
OK
OK
31
Advertisement
Table of Contents
