Sokkia CX-62 Operator's Manual page 278

Out of value
During gradient % display, the display range (less than ±1000%) has been
exceeded.
During REM measurement, either the vertical angle has exceeded horizontal
±89° or the measured distance is greater than 9999.999m.
Install the instrument station far from the target.
The instrument station coordinates calculated during resection are too high.
Perform the observation again.
During setting-out line measurement, scale factor has been less than
0.100000 or exceeded 9.999999.
During area calculation, results exceeded the display range.
Pt already on route
Traverse tried to close on a traverse point other than the Start pt. during
automatic route search. Press any key to return to the last point found in
automatic route search. Either select the next traverse point to continue the
current search or specify the Start pt. to close a closed-loop traverse.
Please use the Star key in obs mode
Can be used only in the Observation mode.
Pt1-Pt2 too near
When setting the baseline with "Point to Line", two reference points are too
close.
Leave the space of 1 m or longer between the two reference points.
Read-only file
Read-only file on the USB memory device cannot be changed and file
contents cannot be edited or deleted.
Same coordinates
The same values are input in Pt.1 and Pt.2 in setting-out line measurement.
CX cannot define the baseline.
SDR format err
The file read in is not SDR format. Check the file.
Send first
JOB data output (transmission to the host computer) is not completed before
JOB is cleared.
Either transmit the JOB to be cleared to the host computer.
34. WARNING AND ERROR MESSAGES
270