Table of Contents
Advertisement
2. Press [TOPO] in the third page of
OBS mode to display <TOPO>.
Select "Coord data" to display the
measurement results.
3. Set the following items.
(1) Target height
(2) Point name
(3) Code
4. Check the input data, then press
[REC].
5. To continue measurement, sight
the next point, press [MEAS], then
perform steps 3 and 4 above.
• Pressing [AUTO] will start
measurement, and automatically
record the measured results. It is
convenient to record measured
data without setting the
collimation height, code and
point name.
• Press [OFFSET] to start offset
measurement.
6. Press {ESC} to quit measurement
and restore <TOPO>.
28. RECORDING DATA - TOPO MENU -
TOPO JOB1
Occupy
BS data
Angle data
Dist data
Coord data
N
E
Z
HR
PT
REC
OFFSET
217
AUTO
MEAS
Advertisement
Table of Contents
