Sokkia CX-62 Operator's Manual page 202

• Middle pitch input range: 0.000 to 9999.999 (0.000*) (m)
• Route width input range: -999.999 to 999.999 (Null*) (m)
• Duplicate point name procedure: Add (record as separate point with same point
name)*/Skip (no overwrite)
• Maximum point name length: 8 characters ("peg No."*)
• Cardinal point settings are retained even when the power has been cut off.
However, the settings have been cleared if "RAM cleared" is displayed.

Rules regarding the assigning of point names to
automatically calculated pegs.
• Clothoid curve cardinal point: the curve number is added at the end e.g. the
KA1 Point of curve number 1 is written "KA1-1", and the KA1 Point of curve
number 2 is written "KA2-1".
• Circular curve cardinal point: the curve number is added at the end e.g. the
BC Point of curve number 1 is written "BC1", and the BC Point of curve
number 2 is written "BC2".
• Width peg: "R" or "L" is added at the end of the center peg point name. "R"
is added for positive (+) route widths (the route width from the center peg to
the RIGHT width peg) and "L" is added for negative (-) route widths (route
width from the center peg to the LEFT width peg). When both route widths
are input as positive (+) "R" and "R2" are used. When both route widths are
input as negative (-) "L" and "L2" are used.
• A blank space at the beginning and end of a point name will be ignored.
• If the length of the point name being input exceeds 16 characters, 1
character at the beginning will be deleted for each new character input at
the end of the point name.
25.8.6 Arbitrary point calculation
The coordinates of arbitrary points on every calculated curve can be found using
arbitrary point calculation.
PROCEDURE
1. In the second page of the OBS mode
screen, press [MENU], then select
"Road".
2. Select "Alignment" to enter the Route
Calculation menu.
25. ROUTE SURVEYING
194