Sokkia CX-62 Operator's Manual page 206


• The rules regarding the assigning of point names to width pegs and center pegs
are the same as those for when calculating width pegs in automatic calculation
of cardinal points.

"25.8.5 Automatic calculation of cardinal points  Rules regarding the
assigning of point names to automatically calculated pegs"
• The rules regarding the assigning of point names to center pegs are the same
as those for when calculating arbitrary points.

"25.8.6 Arbitrary point calculation
automatic assigning of point names to arbitrary points"
25.8.8 Setting parameters
When configuring curve properties in "25.8.2 Inputting Curve Elements", it is
possible to preset which curve (clothoid or parabola) to calculate and which point
to use as the BP Point of the next curve: the IP Point of the previous curve or the
end-point (KA-2 or EC Point) of the previous curve.
PROCEDURE
1. In the second page of the OBS mode
screen, press [MENU], then select
"Road".
2. Select "Alignment" to enter the Route
Calculation menu.
3. Select "Setting" to enter the Setting
Parameters menu.
4. Use {}/{} to select the automatic
setting method for the BP Point of the
next curve and curve type.
25. ROUTE SURVEYING
 Rules regarding the
A l i g n m e n t
D e f i n e e l e m e n t s
A u t o c a l c .
C a l c c o o r d
R o a d t o p o
S e t t i n g
Alignment/Setting
Next BP : IP
Curve
198
:Clothoid