Sokkia CX-62 Operator's Manual page 196

• If the element starting point is located before the BP, the distance between
those two points is displayed with minus (-).
• If the element ending point exceeds the EP, the distance between those two
points is displayed with plus (+).
Pressing [YES] continues the calculation, ignoring the overlap of the curves.
Pressing [NO] stops the calculation and return to the Input Element screen.
1. Input the IPs.

"25.8.1 Inputting IPs (Intersection
Points)"
2. Enter the Input Element screen.
Select "Input element".
3. Input the elements for the curve 1.
Input the parameter A1, parameter A2,
radius R, and offset (additional
distance for the BP: if the BP is located
before the route starting point, minus (-
) is accompanied) and press [OK].
• To set a dogleg, parameter A1 and
A2 should be "Null" and radius
should be 0.
B P - E l e m e n t 1
- 1 0 m m
C u r v e o v e r l a p
C o n t i n u e ?
YES
E l e m e n t n - E D
1 0 m m
C u r v e o v e r l a p
C o n t i n u e ?
YES
188
25. ROUTE SURVEYING
NO
NO
Define elements
Input IP
Input element
Review element
Clear
E l e m e n t 1
P a r a A 1
P a r a A 2
R a d i u s
S t . o f s
5 0 . 0 0 0 m
5 0 . 0 0 0 m
6 0 . 0 0 0 m
0 . 0 0 0 m
I P OK