Sokkia CX-62 Operator's Manual page 197

• When [IP] is pressed, the intersection
angle, turning direction, the lengths
of the curves between BP-IP1 and
IP1-IP2 are calculated from the BP,
the IPs and the curve elements, and
the results are displayed. After
checking the results, press [OK].
4. Input the elements for the next curve.
Input the parameter A1, parameter A2
and radius R for the next curve. The
offset is automatically set.
• The offset is not displayed if "Next
BP" described in "25.8.8 Setting
parameters" is set to "IP".
• When [IP] is pressed, the intersection
angle, turning direction, the lengths
of the curves between IP1-IP2 and
IP2-IP3 are calculated from the BP,
the IPs and the curve elements, and
the results are displayed. After
checking the results, press [OK].
5. Continue inputting the elements for
the following curves.
Input the elements for the following
curves in the same manner as shown
in steps 3 and 4.
6. Quit inputting the curve elements.
When input of the elements for all
curves is completed, press [OK]. The
screen will return to <Curve Element
Setting>.
25. ROUTE SURVEYING
E l e m e n t 1
I A
D i r e c t .
B P - I P 1 :
I P 1 - I P 2 :
E l e m e n t 2
P a r a A 1
P a r a A 2
R a d i u s
S t . o f s
189
90 00 00
: R i g h t
1 4 1 . 4 2 1 m
1 4 1 . 4 2 1 m
OK
< N u l l >
< N u l l >
5 0 . 0 0 0 m
1 9 5 . 3 8 6 m
I P OK