Table of Contents
Advertisement
• When the cursor is on "Azmth1"
or "Azmth2", [COORD] is
displayed. Press [COORD] to
set the azimuth angle for each
point by inputting coordinates.
• Press [MEAS] to observe the
selected point.
5. Press [OK]. The coordinate value
of the intersection point is
calculated and displayed
• When there are 2 intersections,
[OTHER] is displayed.
" 2 Intersections"
• Press [S-O] to move to setting-
out measurement of the required
point.
"15. SETTING-OUT
MEASUREMENT"
6. Press {ESC}. Continue the
measurement (repeat steps from
2).
• It is also possible to perform intersection measurement by pressing [INTSCT]
when allocated to the OBS mode screen.
Allocating [INTSCT]: "33.3 Allocating Key Functions"
N p :
E p :
Z p :
LOAD
A z m t h 1
H . d i s t 1
.
A z m t h 2
H . d i s t 2
I n t e r s e c t i o n 1
N
E
Z
OTHER
153
23. INTERSECTIONS
1 s t P T
0 . 0 0 0
0 . 0 0 0
< N u l l >
REC
MEAS NEXT
:
4 5 0 0 ' 0 0 "
:
< N u l l >
:
< N u l l >
:
5 0 . 0 0 0
m
OK
1 7 6 . 4 5 8
1 7 6 . 4 5 8
< N u l l >
REC
S-O
Advertisement
Table of Contents
