Pull-Type: Flatbed - MacDon A30-S Operator's Manual

6.8.3

Pull-Type: Flatbed

To transport the mower conditioner on a flatbed
trailer, proceed as follows:
CAUTION
Use the following
transporting the mower conditioner on a
flatbed trailer.
6.8.3.1 Loading: Pull-Type
a. Lower mower conditioner to the ground, and
move the cylinder lock-out valve handle to the
"horizontal" position at both lift cylinders.
b. Retract header angle control link to "minimum".
c. Unhook mower conditioner from tractor. Refer
to Section 6.5
TRACTOR UNHOOK: PULL-TYPE.
d. Tie hoses to APT.
e. Remove tall crop dividers (if equipped) as
follows:
C
1. Remove U-bolt (A) and bolts (B) securing
crop divider (C) to lean bar, and remove
crop divider.
2. Repeat for crop divider at opposite end.
Form 169000 / 169040
SECTION 6 OPERATION
procedure when
MOWER CONDITIONER/
A
B
f. Remove complete forming shield group as
follows:
A
1. Remove pins (A).
2. Disassemble adjuster bars (B) from side
deflectors (C). Note orientation of hardware.
E
3. Remove nuts (D), and drop side deflectors
from frame (E).
4. Remove ten bolts (F) attaching forming
shield cover to frame.
G
5. Remove two bolts (G), and lower rear of
forming shield to ground.
6. Remove two bolts (H), and detach forming
shield from frame.
54
C
B
D
F
F
F
H
(continued next page)
Revision D