Header Attachment: Self-Propelled; A30-S, A30-D - MacDon A30-S Operator's Manual

6.6 HEADER ATTACHMENT: SELF-
PROPELLED
Refer to your
Operator's Manual
mechanically attaching the auger header to the
self-propelled windrower, and for modifications if
required to the windrower hydraulic connections.
Refer to the following procedures for electrical
and hydraulic connections.
hydraulic hoses and electrical harness are
located on the LH cab-forward side of the
windrower.
6.6.1

A30-S, A30-D

6.6.1.1 M100, M105, M150, M155
The M100, M105, M150, and M155 Windrowers
are factory-equipped with A30-S and A30-D
header hydraulics
Proceed as follows:
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
B
a. Disengage rubber latch (A), and open driveline
shield (B).
Form 169000 / 169040
SECTION 6 OPERATION
Self-Propelled Windrower
for procedures
Header drive
and electrical harness.
A
for
E
b. Remove the cap (C) from electrical connector,
and remove connector from support bracket.
E
c. Disengage
clockwise to "fully up" position to release the
hose bundle (E).
d. Move hose bundle (E) to header.
e. Rotate lever (D) clockwise, and engage in
bracket to store.
If the hose bundle contains four hoses
(draper header operation), only three are
required to power the A30 header.
Ensure loose hose is properly secured to
avoid contact with the drivelines.
35
D
and rotate lever
NOT USED
IMPORTANT
(continued next page)
C
D
(D) counter
Revision D