Performing A Measurement - Ametek mocon Dansensor CheckMate3 User Manual

®
Dansensor CheckMate 3

Performing a measurement

1. Make sure that the device is in Ready mode - see
2. Select appropriate product - see
3. Place a septum
leak-free gas extraction and thus accurate measuring.
4. Penetrate the septum
package through the tip.
CAUTION! Do not let the needle tou17ch the product, fluid or anything else in
the package, as this could soil the needle, hose or filter.
If this happens, the needle, hose and filter must be replaced to avoid destroying
sensors or other items inside the unit.
5. The measuring method is displayed at the top of the screen
6. If selected product requires keying in of data before measurement (see
page 33 for details) Data required. Press
measuring screen
Data required. Press
7. Pressing the
the required data. Key in the data and confirm by pressing the OK key, which will either
bring up the next data request screen if required or return to the measurement screen
ready for measuring.
8. Now start the measurement as required - see
EN
"Selecting a product for measuring" on page

on the product/package

with the needle
4

.
5
key will bring up the appropriate touch screen keyboard for keying in of
"Modes" on page 15.

to be measured/analysed. This ensures

so that the gas can be sucked in from the

.
will be displayed in the bottom of the
"Measuring modes" on page 22
User Guide
23.
"Edit product" on
for details.
P/N 300042-I
05/2019
25