Replacing Printer Paper - Ametek mocon Dansensor CheckMate3 User Manual

®
Dansensor CheckMate 3

The needle may sometimes touch the product being measured or the needle may suck
fluid from the packaging from which the measurement is taken. If this happens, it will be
necessary to replace both the needle and the filter.
If there is any dirt or fluid in the measuring gas hose
using dry compressed air.
All of the parts can be ordered (and replaced) separately or as a complete kit.
See "Consumable parts and options" on page

Replacing printer paper

(Only models with printer)
4
3
To replace printer paper roll do the following:
1. Open the paper roll tray
2. Place new paper roll
the printer catches it.
3. Press the

.
4. Close paper tray
CAUTION! Do not touch the paper tear-off mechanism located at the top of the
upper paper slot
EN
1
2

by pulling it outwards, then remove the empty paper roll.

in the tray and lead the paper into the lower paper slot
key a couple of times until paper is led out through the upper paper slot

.

as there is a risk of cutting your fingers.

, it should be replaced or cleaned
56.
User Guide 29

until
P/N 300042-I
05/2019