Ametek mocon Dansensor CheckMate3 User Manual page 28

26 User Guide
9. When measuring finishes (or in case of periodic measuring, after each measuring) the
recent result is shown on the screen
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product
2,49
72,4
For continuous measurements the measuring results are displayed continuously on the
screen during the measuring.
If any alarm limits have been defined, the results are shown in different colours - see
Measuring screen" on page 21
10. If device has been set up to use the Mark measurement as invalid function (only for
Auto spot and Manual spot measurements) the screen becomes touch sensitive for a
short while (5 sec.), while the upper section displays the text Press here to mark
measurement as invalid on an orange background
Press here to mark measurement as invalid
Product
If you wish to invalidate the recent measurement, press anywhere on the screen. This will
bring up a confirmation screen.
Warning
Mark last measurement as invalid?
Select Yes and press
11. If selected product requires keying in of notes after the measurement (only for Auto spot
and Manual spot measurements) (see
required. Press
12. Pressing the
the required note data. Key in the data and confirm by pressing the OK key to return to
the measurement screen ready for another measuring.
P/N 300042-I
05/2019
08/17/06 13:46
Menu
25,1
% %
O CO
2 2
Bal
Press to measure
for details.
Menu
13:46
08/17/06
No
Yes
to confirm.
NOTE! If you want to save measurement as invalid, make sure to confirm this
before entering any notes for the measurements if required (see item 11).
Otherwise measurement will automatically be saved as valid.
will be displayed in the bottom of the measuring screen
Note required. Press
key will bring up the appropriate touch screen keyboard for keying in of
EN

.
6

.
7
"Edit product" on page 33
8
®
Dansensor CheckMate 3
"The
for details) Note

.