Single And Two Point Power Connection Conversion - Champion M2 Series Installation Manual

Single to Two Point Power Connection Conversion
1. Machine wiring can be converted from a single to a two point input power connection
by installing a field conversion kit, P/N 901168.
2. New electrical connection data plates must be applied in front of the input terminal blocks.
3. Refer to end of this manual for conversion instructions.
3 Phase Power Connection
208-240/480V/60/3
L1
L2
L3
Fig. 12 - 3PH terminal block
L1 L2
L1 L2
LINE IN
L1 L2
L1
LINE IN
L1
L2
L3
GND
L3
2-Point Machine Connection Data Plate
Mod: DH6000T Series: M2-STD
GND
For supply connection, use copper connectors in accordance
with local electrical code. Rated Minimum 90°C (194°F).
Overcurrent Protection Device: Time Delay or Inverse Time
Circuit Breaker
Minium Supply Conductor Ampacity
Maximum Supply Overcurrent
Protection Device
Volt: 208-240
L3
2-Point Booster Connection Data Plate
L3
Mod: DH6000T
For supply connection, use copper connectors in accordance
with local electrical code. Rated Minimum 90°C (194°F).
GND
Overcurrent Protection Device: Time Delay or Inverse Time
Circuit Breaker
Minium Supply Conductor Ampacity
Maximum Supply Overcurrent
Protection Device
Volt: 208-240
L2
L3
Fig. 14 - 2-Point data plates
1 Phase Power Connection
208-240V/60/1
L1
L2
NOT
USED
Fig. 13 - 1PH terminal block
50/50 AMPS
50/50 AMPS
Ph: 3 Hz: 60 Amp: 38-34
Series: M2-STD
50/50 AMPS
50/50 AMPS
Ph: 3 Hz: 60 Amp: 39-34
Installation
L1
L2
NOT
USED
GND
9