Dish Table Connections - Champion M2 Series Installation Manual

Installation

Dish Table Connections

CAUTION:
Do not attach the dish tables until the dishwasher is set in its permanent location.
Side
panel
Level the dishwasher and dish tables to the required height. Fit the dish table flanges over
the ends of the dishwasher tank and mark two hole locations. Drill 1/4" holes through the table
flange and the dishwasher tank. Apply sealant between the table flanges and the wash tank and
install stainless steel 1/4-20 fasteners to secure.
2
Dish table flange
Drill holes, apply sealant,
& fasten flange to wash tank
1/2"
Fig. 2 - Dish table installation (if required)
Dish table
Fig. 3 - Nominal dish table configuration
Inner wall of
wash tank
Dish table