Supervisor Menus (Continued) - Champion M2 Series Installation Manual

Supervisor Menus - Optional Champion Chemical Dispenser Set-up
SUPERVISOR MENUS
Optional Champion Chemical Dispenser Set-up
Instructions for the Supervisor and Chemical Supplier
SET DETERGENT CONCENTRATION - (See Fig. 39 a,b,and c for Sensor displays).
1. The concentration display indicates the sensor that is ON.
2. Setpoint value sets the amount of detergent injected.
3. Actual is the amount of detergent detected by sensor.
4. Press DETERGENT PRIME to prime in the event that
it was not completely primed automatically.
5. Press "PUMP" button to agitate wash tank.
6. Fill the dishwasher with fresh water and run cycles
until the tank temperature indicates approximately
160ºF/71ºC.
Fig. 39b - Tank Sensor ON
7. Press the 'Back-up button (◄ ◄ ), (Fig. 39c), to return to the Supervisor menu, (Fig. 39c).
8. Press the 'Home' button, (Fig. 40), to return to the main operation screen, (Fig. 41).
Fig. 40 - Home button
THIS COMPLETES THE OPTIONAL CHAMPION
CHEMICAL DISPENSER SETUP
20
(continued)
Fig. 39c - Tank and In-line Sensors ON
Fig. 41 - Main operation screen
(continued)
Fig. 39a - In-line Sensor ON
PROCEDURE.