Booster Heater Conversion From 1Ph To 3Ph Operation - Champion M4.2 Series Installation/Operation Manual With Service Replacement Parts

Installation

Booster Heater Conversion from 1PH to 3PH Operation

THE BOOSTER HEATER IS WIRED FOR 1PH OPERATION WHEN SHIPPED.
FOLLOW THE INSTRUCTIONS BELOW TO WIRE THE BOOSTER FOR 3PH.
1. To convert the booster heater from single phase to three phase operation, locate the
booster wire labeled 1H3 that is cable-tied to the booster hose.
2. Remove the shrink insulation from the terminal and connect to the booster heater
element as shown in the wiring diagram on page 72.
The three phase booster wire (1H3) is cable-tied to the hose adjacent to the booster tank.
6
! VERY IMPORTANT !
WARNING:
Electrocution or serious injury may result when working on an
energized circuit.
Disconnect power at the main breaker or service disconnect switch
before working on the circuit.
Lock-out and tag the breaker or service disconnect switch to
indicate that work is being performed on the circuit.