Detergent Sensors; Detergent Prime And Rinse Aid Prime Buttons; Set Rinse Aid Set Point; Set Detergent Cycle Times - Champion M2 Series Installation Manual

Optional Champion Chemical Dispenser Set-up
Instructions for the Supervisor and Chemical Supplier
Chemical Setup Menu:
Sensor Options:
Chemical dispensing controlled according to option
IN-LINE only, TANK only or both IN-LINE and TANK.

DETERGENT SENSORS :

1. Press 'IN-LINE' button ON if optional
detergent sensor installed (Fig. 30).
2. Press 'TANK' button ON if tank
detergent sensor installed (Fig. 30).
3. Press both ON if both installed.

DETERGENT PRIME and RINSE AID PRIME BUTTONS:

1. Manually runs the chemical pumps.
2. To prime: Insert pick-up hose(s) in chemical containers.
3. Press and hold a PRIME button. Release button.
SET RINSE AID SET POINT: (factory default = 5 secs.)
1. Rinse aid pump runs for 5 secs. during the final rinse.
2. To change: press "5". Keypad appears, (see Fig. 28).
3. Press CLR, new value, and ENT.
SET DETERGENT CYCLE TIMES, (Fig. 25):
1. Press "CYCLE TIMES" Factory default Prime = 40 secs., Fill = 30 secs.,Cycle = 3 secs.)
2. To change: press "number on the screen,
Keypad appears, (see Fig. 28).
3. Select new value on keypad, then ENT.
4. Repeat for each value needing change.

IN-LINE Sensor (ONLY) Normal Operation:

1. Detergent pump output = 3ml/sec.
2. At power on, the detergent pump will run for 40 secs.
or until the in-line sensor detects chemical.
3. When the lower float is satisfied, detergent pump runs 30 secs. for initial charge.
4. The detergent pump runs 3 secs. at the beginning of each wash cycle.
Supervisor Menus - Optional Champion Chemical Dispenser Set-up
)
(continued
(continued on next page)
(continued)
Fig. 30 - IN-LINE sensor selected.
Fig. 31 - In-line sensor
Fig. 32- Tank sensor
Fig. 33 - In-line sensor cycle times
17