In-Line Sensor Only Detergent Cycle Times; Inline Sensor Operation Error (A); Tank Sensor Normal Operation; Tank Sensor Error Operation - Champion M2 Series Installation Manual

Supervisor Menus - Optional Champion Chemical Dispenser Set-up
SUPERVISOR MENUS
Optional Champion Chemical Dispenser Set-up
Instructions for the Supervisor and Chemical Supplier

IN-LINE SENSOR ONLY DETERGENT CYCLE TIMES

IN-LINE Sensor Operation Error (A):
1. If the IN-LINE detergent sensor does not detect chemical within the 40 sec. prime cycle,
then, a flashing yellow bottle symbol
appears on the operation screen indicating
a 'DETERGENT LOW ALERT', (Fig. 34).
2. Check the chemical supply then press the
flashing bottle to run the pump 40 secs.
3. The flashing yellow bottle will disappear
when the IN-LINE sensor detects chemical.
IN-LINE Sensor Operation Error (B):
1. The detergent pump runs for 3 secs. before
each wash cycle. If the IN-LINE sensor does
not detect chemical after three consecutive cycles, the flashing yellow bottle will appear.
2. Check the chemical supply and press the flashing yellow bottle to reset the alert.
Repeating "LOW DETERGENT ALERT:
The flashing yellow bottle will continue to reset and periodically reappear until the cause of alert is repaired.
The dishwasher continues operating even with the error.
Detergent Alert.

TANK Sensor Normal Operation:

1. Detergent pump output = 3ml/sec.
2. Machine fills.
3. When the lower float is satisfied, detergent
pump runs for the fill set point to achieve
the initial detergent charge.

TANK Sensor Error Operation:

1. If machine has run one cycle, and tank temperature is 150ºF/65.6ºC or greater, and,
the tank sensor is not satisfied, then the detergent pump will pump the cycle time set
point.
2. Detergent pump waits 20 secs. and pumps the cycle time set point again or until
the sensor is satisfied.
3. When the wash pump is running, the detergent pump will run If the sensor dectects the
detergent is below its setpoint for 5 consecutive seconds.
4. This is repeated for two minutes or until tank sensor is satisfied. The flashing yellow
bottle "LOW DETERGENT ALERT" will appear if tank sensor is not satisfied within two
minutes.
18
(continued)
(continued
Fig. 34 - DETERGENT LOW ALERT - (flashing bottle)
CFA machines will lockout if there is a Low
(continued)
):
Fig. 35 - Tank sensor selected.