Cleaning Schedule - General - Structural Concepts Impulse 62486 Operating Manual

CLEANING SCHEDULE - GENERAL (DAILY "D" / WEEKLY "W" / MONTHLY "M")
Cleaning D
Clean Case X
Exterior
X
Clean Case X
Interior
X
W M
Clean wood, laminate and painted surfaces (including shelves) with a warm
soap and water solution and soft cloth. Never use wire cloth or abrasive
cleaners on case.
CAMBRIA® NATURAL QUARTZ SURFACE (Countertop): See next page
for complete instructions.
X Trash Chute Assembly. See TRASH BIN REMOVAL / TRASH CHUTE
REMOVAL (FOR CLEANING PURPOSES) section in this manual for
photos and step-by-step removal instructions.

Submerse in warm soapy water.

Clean with soft, non-abrasive cloth.

Never use wire cloth or abrasive cleaners on stainless steel material.

Wipe down trash disposal flap with warm soap and water solution and
soft cloth before reinstalling trash chute assembly.
Hatco® Heated Wells. See HATCO® HEATED WELLS - CLEANING
GUIDELINES & SCHEDULE section in this manual.
Magnetic Filter (For Condensation Fans). See CONDENSATION FANS /
CONDENSATION FAN FILTER section in this manual for locations:
Remove from case. Submerge in water and mild detergent solution. Use
soft-bristled brush to remove smoke and grease from filter. Rinse
thoroughly and allow to dry.
X Stainless steel utensil dispensers and surfaces (bowl & lid dispensers, fork,
spoon & knife dispensers, decks, etc.). Remove all supplies. Wipe down
areas with warm soap and water solution and soft cloth.
Caution! Never use abrasive material such as steel wool or 'Brillo® Pads'
to clean stainless steel areas. Do not use abrasive cleaners with gritty or
harsh chemicals to clean stainless steel areas as these can scratch the
finish, dulling and marring its appearance.
X Monthly (or as needed): Trash Bins. See TRASH BIN REMOVAL (FOR
CLEANING PURPOSES) section in this manual. Wipe down with warm
soap and water solution and soft cloth.
Task
62