Advertisement
Acre Meter can not change the width or pulse count
settings or clear the field and total acres.
1. Check to see if a password needs to be entered by
pressing the *(FUNC) key until the P-Word indicator
LED is lit. If "dIS" is displayed (password disabled) no
password is set.
2. If "Ent" is displayed a password must be entered to
change the settings or the password must be disabled
as instructed in the setup section of this manual.
Storage
1. The service life of the Seeder will be extended by
proper off-season storage practices. Prior to storing
the unit, complete the following procedures:
•
Completely clean the unit, blow all seed out of
Seed Meters.
•
Inspect the machine for worn or defective parts.
Replace as needed.
•
Repaint all areas where the original paint is worn
off.
•
Apply a light coating of oil or grease to exposed
cylinder rods to prevent them from rusting.
•
Lubricate each point of the machine as stated in
"Lubrication Maintenance" on page 5-3.
•
Reduce Rear Roller Air System Air Pressure to
15psi if stored for an extended period of time.
2. Store the unit in a shed or under a tarpaulin to protect
it from the weather. The ground engaging
components and tires should rest on boards, or some
other object, to keep them out of the soil.
3. 3-PT Hitch Models: Raise track removers, lower
Parking Stands, and insert Parking Pin before
unhitching from tractor.
4. Pull Type Models: Raise the machine and install
Transport Locks. See Figure 3-5. Lower Drawbar
Jack.
•
Relieve Hydraulic Pressure in hoses after
Transport Locks are installed.
•
Block transport wheels before unhitching from
tractor.
F-1021-0422
TABLE OF CONTENTS
5-9
Advertisement
