Advertisement
Drawbar Model Warning
Lamps Installation
Amber Lamps are assembled to the outer extremity of
machine.
1. With the Warning Lamp Bracket bends inward, mount
a Warning Lamp Bracket to the inside of each end
Frame Bracket with 1/4-20 x 1 Bolts and Locknuts.
See Figure 2-10.
2. Secure Lamp Shields onto Warning Lamp Brackets
with 1/4-20 x 1 Bolts and Locknuts.
3. Unscrew Amber Lamp Jam Nut if not already
removed from Lamp Stud so that the Nut and
Washers fall down to the plug. Place an Amber Lamp
inside a Lamp Shield so that the Lamps threaded stud
sits in the radius of the slot and insert the stud into
each Warning Lamp Bracket slot. Secure Amber
Lamps with Jam Nut and Washers.
4. Attach Lamp Shields to the Wheel Arm Shields with
1/4-20 x 1 Bolts and Locknuts.
5. Red Lamps are assembled to the Wheel Arm Shields.
Install the Red Lamps inside the Lamp Shields by
sliding the lamp stud into the slot. Secure Red Lamps
with Jam Nut and Washers.
6. Attach the Flasher Control Module onto the inner
Drawbar Bracket with 1/4-20 X 1-1/2 Bolts, Flat
Washers and Locknuts.
IMPORTANT
Cords are marked Yellow for Left and Green for
Right.
7. Lay out the Lamp Harness and attach the harness to
the Flasher Control Module.
8. Route the left and right 3 plug cord along the frame
and connect to each Red Lamp.
9. Route the remaining left and right 2 plug cord along
the left and right of the frame and under the Seed Box
Supports, connect into each Amber Lamp.
10. Lay out the 7-Pin Harness and attach the harness to
the Light Module.
11. Attach SMV Sign to SMV Bracket with 5/16-18 x 1
Bolts, Flat Washers and Locknuts.
12. Route the 7-Pin Harness through the Hose Support
and up the Drawbar.
13. Bundle and secure with tie wraps after Nylon Tubing,
all Harnesses and Hydraulic Hoses have been
installed.
2-10
TABLE OF CONTENTS
IMPORTANT
All harnesses must be firmly attached to machine
frame members, or nylon tubing, so they don't sag or
become torn loose by field debris. Use the tie wraps
provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or
interfered with while rotating frame from transport to
field working position and vice versa.
NOTE
The 7-Pin harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
Cut Outs on the left front side of the Drawbar. Allow
enough harness length to reach tractor socket and roll or
fold up excess and secure to hydraulic hoses or Drawbar.
F-1021-0422
Advertisement
