Advertisement
2. Install Elbow Fitting into rod end of each 3 x 8
Hydraulic Cylinder. See Figure 2-9.
3. Install Bulkhead Tees into SMV Bracket using
supplied hardware.
4. Install Elbow Restrictor into base end of each 3 x 8
Hydraulic Cylinder.
5. Attach a 3/8 x 53 Hose to each Cylinder Base End
Elbow Restrictor and a 3/8 x 64 Hose to each Cylinder
Rod End Elbow.
Male Coupler,
08 O-Ring
Adapter,
3/8 x 214,
08MJ x 08MOR
Hose Asm
Bulkhead Tee,
06MJ
3/8 x 53,
Hose Asm
3 x 8,
Hyd Cyl
F-1021-0422
TABLE OF CONTENTS
6. Route the hoses along frame to Bulkhead Bracket
7. Connect 3/8 x 214 Hoses to Bulkhead Tees, route the
8. Install 08MJ x 08MOR Adapter and Male Coupler into
9. Once the Seeder has been assembled, purge the Lift
SS16 HydSchematic
Elbow Restrictor,1/16
3/8 x 64,Hose Asm
Elbow,08MJ x 08MOR
Figure 2-9: Hydraulic Schematic
and attach to Bulkhead Tees.
hoses up the Drawbar.
each hose end.
Circuit. See "Purge Hydraulic Lift System" on
page 3-6.
3/8 x 53,
Restrictor,1/16
Hose Asm
3 x 8,
Hyd Cyl
Elbow
3/8 x 64,
Hose Asm
Elbow,
08MJ x 08MOR
2-9
Advertisement
