Advertisement
Attaching/Detaching 3-PT Hitch
Seeder
WARNING
To prevent the implement from tipping forward on
the frame, disengage parking stand only when the
seeder is fully attached to the tractor. Be sure to
observe the following sequences.
Hooking Up the Seeder:
1. Attach seeder to the tractor. Raise the Seeder.
2. Remove the 3/4" Pin and lift the Parking Stands until
the bottom hole is aligned with the bracket hole.
Replace the 3/4" Pin. Both sides. See Figure 3-2.
3. Remove the 3/4" Parking Pins from the Frame Arm
Guides and place into frame tabs. Both sides. See
Figures 3-3 and 3-4.
Unhooking the Seeder:
1. Raise Seeder, remove the 3/4" Pins and lower the
Parking Stands, align one of the three holes with the
bracket hole depending upon the site ground, replace
the 3/4" Pins. Both sides. See Figures 3-2.
2. Insert the 3/4" Parking Pins into the Frame Arm Guide
to lock the Rear Roller Arms. Both sides. See
Figure 3-4.
3. Lower Seeder and disconnect the tractor from
Seeder.
3/4" Pin
Parking Stand
Figure 3-2: Parking Stand (Shown with parts
removed for clarity)
3-4
TABLE OF CONTENTS
Frame
Rear Roller
Arm Locked
3/4" Parking Pin
Frame
Arm Guide
Figure 3-3: Parking Pin Stored
Arm Guide
Figure 3-4: Parking Pin Engaged
3/4" Parking Pin
F-1021-0422
Advertisement
