Advertisement
Clutch Operation - Optional
Brillion Elite Mini Monitor: Touch Screen Monitor
provides the user the ability to toggle the Seeder Clutch
"On" or "Off".
Basic Clutch Switch: Toggle Switch on Switch Box,
turns the Seeder Clutch "On" or "Off".
Console w/Clutch Control: Toggle Switch on Switch
Box, turns the Seeder Clutch "On" or "Off".
Clutch characteristics are as follows:
1. The Clutch is engaged when power (12 Volts) is
applied.
2. The Seeder has provisions to mechanically lock the
Clutch to drive the Seed Metering System, by aligning
the hole in the Clutch Shaft with the slot in the Clutch
Hub and securing with a 1/4 x 1-3/4 Bolt, Flat
Washers and Locknut. See Figure 3-14.
3. The Clutch must be disengaged (power off) when
Seed Shafts are turned manually for calibration.
4. Check clutch operation: Clutch will engage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while toggling the Seeder Clutch "On" and "Off". The
Seed Shaft will stop rotating when switch is turned to
"Off" position.
IMPORTANT
At no time use high pressure water or air to clean the
clutch as damage could occur.
Bolt,1/4-20 x 1-3/4
Flat Washer,1/4
Clutch Hub
Clutch Shaft
Locknut,1/4-20
Flat Washer,1/4
Figure 3-14: Clutch Lock Bolt
F-1021-0422
TABLE OF CONTENTS
Clutch
3-11
Advertisement
